Batteries

TG500 & TG501

TG500 Battery for heated gloves
TG501 Battery for heated shirts
Lithium ion batteries 7.4V power
Duration up to 7 hours
800 to 1000 charge / discharge cycles

UGS : TG500 Catégorie :

Description

TG500 Battery for heated gloves

Type Li-Ion, 2700 mAh capacity and 7.4V power
800 to 1000 charge / discharge cycles
Duration up to 7 hours

TG501 Battery for heated shirts

Type Li-Ion, 4400 mAh capacity and 7.4V power
800 to 1000 charge / discharge cycles
Duration up to 7 hours

Batteries and Charger

The battery life depends on the level of heat used at the time, reaching a maximum of 5 hours. The batteries are lithium ion high performance, and can reach 1000 charge / discharge. Connected to the mains using the charger can not handle more cargo when it reaches the limit. This potential failures and risks of overcharging are eliminated. The Lithium-Ion batteries are much more efficient than those based on nickel, which do not require a long initial load.

All products are supplied with a universal AC charger 100v-240v with LED charging indicator. It requires a period of « running » because its maximum capacity is available from the first use. A battery lithium ion is indifferent to a load is the number 1, 30 or 523, no memory effect. Its composition makes it preferable partial to full downloads. So you should NOT completely drain the battery before recharging to improve its performance.

Maintenance and care

When not using the product always disconnect the battery. For optimal performance, it is advisable not to fully recharge the battery if the product is not being used for a long period of time. For optimum storage charge the battery for 20 minutes, after 90 days without use. You must fully charge the battery before using the product again, once you return to normal use. The preservation of the product and the battery must be in a cool, dry place.
The batteries are lined with a padded acrylic fabric to ensure better protection and care for any contact.

You can request replacement batteries to extend the operating time of the product.